Installing front wheel sensor
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Clean the sensor seat of dirt and rust so that the sensor is in the correct position relative to the pulse wheel.
Clean dirt from the pulse wheel using compressed air.
Connect the connector and install the two screws to the inside of the wing.
Install the plastic inner wing.
Clean the mounting surfaces so that the sensor can be fitted easily. Lightly grease the sensor.
Install the sensor. Tighten to 25 Nm.
Press the sensor cable into the support.
Install the wheel, see Installing the wheels .