Installing the transmission
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Use a mobile jack and transmission fixture to adjust the height and angle.
Locate the transmission on the engine.
CAUTION:
Take care not to damage the ring on the carrier plate for the flywheel sensor.
Reinstall the screws (six screws). Tighten alternately to light pressure. Then tighten alternately.
Tightening torque: 50 Nm .
CAUTION:
When tightening the screws carefully check that the guide bushings locate correctly in their guide holes and that the torque converter cover is in contact with the engine before tightening.
Remove the fixture and mobile jack from the transmission.