Installing the torque converter screws
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Use new screws, Torx TX50.
Locate the torque converter on the carrier plate by turning engine using the crankshaft pulley nut (accessible through the fender liner hatch).
Install all screws loosely (six screws). Tighten the screws until the heads are in contact with the carrier plate.
Then tighten to 35 Nm . Socket Torx TX 50.
CAUTION:
Remove the socket from the crankshaft when the work is complete.