Installing the clutch cylinder

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Clutch Cylinder

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tighten the screws. Tighten to 10 Nm .

Thread the rubber seal onto the pipe with the boot turned towards the clutch cylinder.

Remove the protective plug. Install the junction. Always use a new quick-release connector with a rubber seal.

Lubricate the rubber seal using a drop of brake fluid. This facilitates joining.

Press the pipe into the junction. Lock the pipe using the clip.

Fig 1: Identifying Clutch Cylinder

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tighten the screws. Tighten to 10 Nm .

Thread the rubber seal onto the pipe with the boot turned towards the clutch cylinder.

Remove the protective plug. Install the junction. Always use a new quick-release connector with a rubber seal.

Lubricate the rubber seal using a drop of brake fluid. This facilitates joining.

Press the pipe into the junction. Lock the pipe using the clip.