Installing longitudinal member

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Longitdunal Member Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

Longitudinal member under engine (four screws).
Front edge, long screws

Rear edge, short screws

Tightening torque: 69 Nm .

Support member-engine, two screws with new lock nuts . Tighten the rear nut first, then the front.

Tightening torque: 55 Nm .
Heat deflector plate, three screws.