Fitting the torque converter screws.
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Use new screws, Torx TX50.
Fit the torque converter to the carrier plate by rotating the engine with the nut of the crankshaft pulley (accessible through the hatch in the right wheel arch liner) while turning the torque converter at the same time.
Fit all 6 screws finger-tight. Tighten the screws so that the screw heads make contact with the carrier plate.
Then tighten to 35 Nm . Torx socket TX50.
CAUTION:
Remove the socket wrench from the crankshaft once work is complete.