Installing the control system

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Control System Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Ensure the lever for the gear selector is set to neutral.

Align the control system on the lever for the gear selector.

Install:

the screws for the control system
a new gasket for the cover on the control system. Note that the screws are of different lengths (measured in mm).

Tighten the screws alternately to light contact. Then tighten alternately. Tighten to 10 Nm .