Install switch, steering wheel covers and steering wheel

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Steering Wheel, Steering Column Cover, Selector, And Torx Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

2 Torx 20 screws on the switch.
3 Torx 20 screws in steering wheel cover.

CAUTION:

Do not turn the steering wheel when the contact reel is locked as the contact reel pin will shear off.

Allow cable and tie straps to pass through the hole in the steering wheel, then install the steering wheel without turning it.

CAUTION:

The steering wheel must be installed in the correct position in relation to front wheel alignment.

If the steering wheel was not installed straight, it must not be turned on the steering column. Carefully remove the steering wheel and try again.