Removing the SIPS bag control module connector

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Take care when separating the connectors.

If the connector breaks the whole cable harness must be replaced.

NOTE:

Always replace the clip if it has been removed.

Fig 1: Identifying SIPS Bag Control Module Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Press on the side so that the bag goes over the edge (1).

Separate the connector.

Bend the clip at the front edge (2).

Move the clip backwards.

Remove clip.

Install:

In reverse order.