Installing the tailgate lock cylinder
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
Install:
- the lock cylinder
- the outer cover strip
- the four nuts. Tighten to 5 Nm
- the control rod. Press the pin in
- the control rod for the central locking motor.
Check the function.
NOTE:
Adjusting the control rod: remove the control rod by the lock. Press the lock cylinder as far to the right as possible so that the control rod can be pulled out as far as possible. Install the control rod on the lock.
Install the panel according to Installing the tailgate panel .