Adjusting the glass panel vertically
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
- Open and close the sun roof by sliding it forwards and back; do not tilt it.
- Slacken off the screws (1) to adjust vertically
- Adjust the glass panel so that the glass molding is slightly below (1 mm) the headlining at the front and slightly above (1 mm) the headlining at the rear.
NOTE:
First adjust the rear.
- Tighten the screws to 5 Nm
- Open and close the sliding sun roof and check the position again.
- Model years before 2000: Tilt the sun roof and install the apron molding on the inside.
NOTE:
If the apron molding rattles, do not reinstall it. Instead apply black paint to the two screws (1) and the pin (2). Do not remove the pin (2).