Installing boot lid lock mechanism

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Transfer the connecting rod.
Connect the wiring to the lock.
Place the lock and tighten to 10 Nm.
Place the connecting rod in the locking clamp and adjust to the right length by pulling the rod back and pressing on the locking clamp.
Check function.

NOTE: When adjusting the pull-rod, push the lock cylinder as far to the right as possible and pull the motor rod out as far as possible.