Installing boot lid lock cylinder

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The lock cylinder (key part) is not replaceable and delivered as one part.

Place the lock cylinder and connect the wiring, tighten the nuts.
Place the connecting rod in the locking clamp and adjust.
NOTE: When adjusting the pull-rod, push the lock cylinder as far to the right as possible and pull the motor rod out as far as possible.
Check function.
Install the cover panel.