Installing the lift mechanism

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Connect the lift mechanism in the door. Connect the connector.

NOTE: Apply contact grease P/N 1161427 in the connector.

Install the screws (B and C). Tighten by hand.

Slide the window down until the lugs run over the window rail.

Install the two screws (A). Tighten by hand.

Wind the window up and down a few times. Then close the window.

Check the alignment of the window.

Tighten the screws (B and C). Tighten to 8 Nm .

Wind the window down so that the screws (A) can be tightened to 8 Nm .

Wind the window up and down a few times to check the function.

Install:

the side impact protection support and side impact protection block
the run-off profile according to Installing a used run-off profile on the front side door
the door panel according to Installing the panel on the front door .

Clean the window.