Circuit test
WARNING: This page is about a different variant/trim than selected.
The fault is caused by an open-circuit in one of the relay circuits in the lock unit. To determine in which circuit the fault is:
Disconnect the connector at the lock unit.
Check the switches for contact resistance and oxidation according to Contact resistance and oxidation .
Measure the resistance between terminals terminal #4 and #6 on the cable connector.
Other information
- To access and replace the lock unit, see Lock mechanism .
The ohmmeter should read 0 ohm.
- OK
Refer to Checking the component
- NOT OK
Refer to Circuit test (cont.)