Circuit test (cont.)

Measure the resistance between terminal #4 and ground and between terminal #6 and ground on the cable connector.

The ohmmeter should read 0 ohm.

1. The ohmmeter displays a fault between terminal #4 and ground.
2. The ohmmeter displays a fault between terminal #6 and ground.

Fig 1: Identifying Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Select an alternative that corresponds to the above. 

• 1 

  Refer to Checking the unlocking relay circuit 

• 2 

  Refer to Checking locking relay circuit