Installing The Rear Suspension
Carefully raise the rear suspension.
WARNING:
Always check that the car does not lift from the lifting arms of the car lift when working with the lifting table.
Install:
- the parking brake cable on the tie rod and the sub-frame on both sides
- the screws for the front mountings on the sub-frame (install the screws through the brackets). Tighten all the front mountings. Tighten to 80 Nm
- the brake pipes in the plastic clips on the brackets
- the screw for the fuel filter bracket. Tighten to 24 Nm
- the screw for the brake line mounting stay. Tighten to 24 Nm .
Remove the lifting table.