Checking the wiring
- Ignition off
- Breakout box connected.
- Disconnect gearbox connector D.
Check the cable between transmission control module (TCM) terminal #A52 (#A52) and transmission connector terminal #D3 (control module side). Check for a short-circuit to supply voltage. Check the cable for short-circuits to other cables in the circuit.
Check the cable between control module terminal #B10 (#A70) and transmission connector terminal #D4 (control module side). Check for a short-circuit to supply voltage. Check the cable for short-circuits to other cables in the circuit.
Check the cables between connector terminals #D3 and #D4 on the transmission side. Check for damage. Check for short-circuits to other cables in the circuit.
Check the connector. Check for damage and pressed in pins.
Remedy as necessary.
Other information:
Was a fault detected?
- YES
Refer to Verification
- NO
Refer to Checking the wiring and component