Checking the wiring and component
- Ignition off
- Open the transmission control system.
Check the cable between transmission terminal #L (#A11) and temperature sensor terminal #A. Check for a short-circuit to ground. Check for a short-circuit to supply voltage.
HINT: Check the temperature sensor: Measure the resistance between temperature sensor connector terminals #A and #B. The resistance should be between 3.5-3.6 kΩ at 20 °C.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- To replace the cable harness, see Wiring harness / oil temperature sensor, replacing
- To replace the temperature sensor, see Temperature sensor, transmission fluid, replacing
- For information about signals, see Signal specification
- For information about the resistance values, see Component resistance values
- See Checking wiring and terminals
- Continue
Refer to Resetting the adaptation