Checking solenoid STH

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Disconnected

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Disconnect the transmission connector
• Connect adapter 9511505 and breakout box 9813190 to the transmission connector (transmission side)
• Connect an ohmmeter between terminals #C (#A3) and #D (#A4) on the breakout box.

  The solenoid STH resistance must be between 3 and 5 Ω.

  Other information: 

  • To connect the breakout box to the transmission connector, see Connecting the breakout box, GM automatic transmissions
  • For information about signals, see Signal specification .
  Fig 3: Identifying Connector Terminals

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 4: Identifying Ohms Display

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 5: Identifying Line Pressure Solenoid, STH

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Was the resistance OK? 

• YES 

  Refer to Checking the cables in the circuit for solenoid STH 

• NO 

  Refer to Checking the wiring and component