Checking the wiring and component
- Ignition off
- Open the control system.
Check the cable between transmission connector terminal #C2 (transmission side) and the connector for solenoid S2. Check for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults . Also check against the other cables in the circuit. Use the relevant wiring diagram.
Replace solenoid S2 if no faults are found in the cable.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- To disconnect the transmission connectors, see Connectors, transmission, disconnecting / connecting
- To replace the cable harness for the control system, see Wiring harness / oil temperature sensor, replacing
- To open the control system and to check or replace solenoid S2, see Solenoid control system, replacing
- For information about signals, see Signal description. Transmission control module (TCM) .
- Continue
Refer to Resetting the adaptation