Installing the screw for the ground lead and cable conduit

Fig 1: Identifying Cable Conduit And Ground Lead Bracket On Sub-Frame

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the screw for the ground lead bracket in the sub-frame. Tighten to 10 Nm 
• the screw and the ground lead on the transmission. Tighten to 25 Nm 
• the parking heater and the screws. Tighten to 25 Nm 
• the fuel line in the clips on the sub-frame
• the screw in the cable conduit
• the front splash guard
• the splash guard under the engine
• the nuts for the left fender liner and damping protection.

Rivet the fender liner into place.

Install the wheels. See Installing wheels .