LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> S80 Base, 2.5 59, FWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Climate Units - Removal, Replacement And Installation >> Engine Coolant Heater, Fuel Driven (1999-2001) >> Fuel injection nozzle/fan motor/pressure equalizer, replacing >> Installation >> Wires

Fuel injection nozzle/fan motor/pressure equalizer, replacing: Installation: Wires

Fig 1: Identifying Flame Sensor & Rubber Bushing
GLL105239Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the tie strap.

Connect the wiring to the blower fan motor.

The cables must be routed under the nozzle pipe.

Install the flame sensor.

NOTE: Ensure that no cables are routed under the flame sensor.

Install the fan shroud (3 screws).

scientia non olet · About LEMON Manuals