Damper motor, defroster, replacing: Installation

Fig 1: Identifying Damper Motor & Defroster Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Position the motor
• Turn the shaft on the heater unit so that the motor can be installed
• Position the motor
• Install the screws for the motor
• Install the switch.

Left-hand drive 

• Install the glove compartment. See Glove compartment, replacing

Right-hand drive 

• Install the soundproofing panel. See Soundproofing panel, replacing

• Carry out self-adjustment of the damper motor end positions. This is carried out via VIDA communication.