Pipe/hose, compressor, replacing: Installation

NOTE: Always use new O-rings lubricated with compressor oil

Fig 1: Lowering Air Conditioning Aggregate On Left-Hand Side

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the pipe/hose in the mounting on the condenser. Position the pipe coupling.
Thread and tighten the screw by hand as much as possible
Tighten the screw for the pipe coupling from the compressor. Tighten to 25 Nm .

Fig 2: Identifying Lower Mounting For Air Conditioning Aggregate

Courtesy of VOLVO CARS OF NORTH AMERICA.

Locate the air conditioning aggregate against the rubber seals. Tighten the lower screws for the air conditioning aggregate. Tighten to 25 Nm
Check that the seals are correctly positioned.

Fig 3: Air Baffle

Courtesy of VOLVO CARS OF NORTH AMERICA.