Expansion valve, replacing: Installation

NOTE: Always use new O-rings lubricated with compressor oil.

Install the O-rings on the pipe from the evaporator
Install the expansion valve. Thread on the screws. Tighten the screws. Tighten to: 10 Nm
Install the O-rings on the pipes
Position the pipes and the holders towards the expansion valve. At the same time check that the pipes are on the correct holder at the member
Thread in the screw. Tighten the holder with the pipes on the expansion valve. Tighten to: 10 Nm
Install the heat shield. Secure the heat shield using the plastic nuts
Press the clamp together on the member
Install the engine stabilizer brace in the engine compartment. 5 cylinder engine . See Replacing cross stay/upper torque rod
Install the engine stabilizer brace in the engine compartment. 6 cylinder engine . See Replacing cross stay/upper torque rod
Vacuum pump and test the system. See Refrigerant, draining
Fill the system with refrigerant. Check for leaks according to Refrigerant, draining
Connect the battery negative lead. See Battery, replacing