Condenser - Work under the car

Remove: 

• the air baffle.

Remove 

• the pipe coupling from the receiver/dryer.

The lower mounting for the air conditioning aggregate: 

• Partially slacken off the screws on the right-hand side
• Remove the screws on the left-hand side.

Slightly lower the air conditioning aggregate on the left-hand side. This is to access the screw.

Remove 

• the screw from the hose/pipe coupling between the compressor and the condenser.

  Use a curved ring spanner

• the hose from the catch on the condenser. Carefully push the hose to one side.

• Slacken off the lower screws holding the air conditioning aggregate together. Pull the aggregate outwards slightly
• Press the air conditioning aggregate backwards. Lower the condenser slightly. Remove the pressure sensor on the receiver
• Remove the condenser
• Remove the receiver/dryer. See Accumulator/receiver drier, replacing .