Checking for open-circuits and short-circuits

Check the cable between the sun roof module (SRM) terminal #6A and the upper electronic module (UEM) terminal #8A. Check for an open-circuit.

Replace the cable if a fault is found.

Other information:

For further information about signals and other values, see Signal specification
To connect the breakout box, see Connecting the breakout box
To access the sun roof module (SRM) connector, see Control module, sun roof, replacing (1999-) or Control module, sun roof, replacing (2003-2006)
See Checking wiring and terminals .

Fig 1: Identifying Sunroof Module Connector A Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Connector (F) Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Was a fault detected?