Checking the wires and components

Check that shunt 20/29 is undamaged. The resistance between the shunt pin is 0 ohm to 5 ohm depending on between which pin the measurement is taken.

Check the wire between relay 2/83 3 and left and right lower lamp body connector 3A for an open circuit as described in Open-circuit, permanent faults and short circuit to ground as described in Short-circuit to ground, permanent faults .

Check wire between left and right upper lamp body connector 4A and ground point for an open circuit as described in Open-circuit, permanent faults .

Check that the fuse 11D/2 is intact.

Do the necessary corrective action.

Additional information: 

• For information about signals and other values:
  • For MY -2003, see Signal specification
  • For MY 2004, see Signal specification
• To connect the test box, see Connecting the breakout box
• To access relay/fuse box in the boot, see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing .

Fig 1: Identifying Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Relays

Courtesy of VOLVO CARS OF NORTH AMERICA.