Connecting the breakout box

Fig 1: Identifying Ignition In Off Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off
Expose the integrated relay/fusebox in the cargo compartment
Remove fuses 11D/1 and 11D/2 from the integrated relay/fusebox in the cargo compartment
Release the locking hooks on the top of the integrated relay/fusebox in the cargo compartment
Fold the integrated relay/fusebox in the cargo compartment downwards/inwards. The integrated relay/fusebox in the cargo compartment can now be removed
Slacken off the screw holding the rear electronic module (REM) connector so that it can hang free
Disconnect the rear electronic module (REM) connector. The connector may be stiff.

Connect the adapter between the rear electronic module (REM) and its connector. Connect the breakout box to the adapter. Breakout box wiring 9511503 .

Disconnect the breakout box in reverse order.

NOTE: Before the rear electronic control module can be checked and measurements taken, the removed fuses must first be installed.

Other information

For the location of the components, see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing
For further information about signals and other values:
- For MY -2003, see Signal specification
- For MY 2004, see Signal specification