Checking components and wiring
Check that the position sensor for the xenon lamp is correctly installed.
Check the cable between rear electronic module terminal #B8 (terminal #A28) and position sensor terminal #4. Check for a short-circuit to supply voltage.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- For -2003, see Signal specification
- For 2004, see Signal specification
- To access or replace the position sensor for the Xenon lamp, see Replacing position sensors for Bi-Xenon lamps
- See Checking wiring and terminals .
- Continue
Refer to Verification