Checking the cable
Check the wiring. Check for an open-circuit. See Open-circuit, permanent faults . Check for a short-circuit to ground. See Short-circuit to ground, permanent faults .
Check the wiring for all the courtesy lighting.
There are 4 lamps; left front, right front, left rear and right rear.
Check the cable between central electronic module (CEM) terminal #2E and terminal #2 on each lamp. Check that terminal #1 on each lamp is grounded.
Also check the connector for the wiring to the rear courtesy lighting.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- -2004: Signal specification
- 2005-: Signal specification
- To replace the front courtesy lighting, see Courtesy lighting, front, replacing
- To replace the rear courtesy lighting (-2004), see Courtesy lighting, rear, replacing
- To replace the rear courtesy lighting (2005-), see Courtesy lighting, rear, replacing .
- Continue
Refer to Verification