Checking the wires
Check the wires for an intermittent short circuit to ground as described in Short-circuit to ground, intermittent faults , intermittent contact resistance and oxidation as described in Contact resistance and oxidation and an intermittent loose contact as described in Loose connections (terminals) .
Check the wires to each entrance light.
The are 4 lamps, front left, front right, rear left and rear right.
Check the wire between central electronic module (CEM) 2E and 2 for each lamp.
Check that there is ground on 1 to the lamp.
Also check the connector for the wires to the rear entrance lighting.
Additional information:
- To connect the test box, see Connecting the breakout box
- -2004: Signal specification
- 2005-: Signal specification