Checking the wiring and switches

Check the signal cable for the lock position sensor between the central electronic module connector terminal #C3 and lock unit connector terminal #5. Check for a short-circuit to ground.

NOTE:

Diagnostic trouble code (DTC) REM-6A0C or REM-6A0E may also be stored if this fault occurs. Click the VCT2000 symbol to read diagnostic trouble codes (DTCs).

Other information:

To access and replace the lock module, see Door module (power windows, power mirrors, child locks, central locking), front doors
For information on the central electronic module connectors, see Central electronic module (CEM), replacing
To connect the breakout box, see Connecting the breakout box
For further information about signals and other values:
- -2004: see Signal specification
- 2005-: see Signal specification
See Checking wiring and terminals. Permanent fault .

Fig 1: Breakout Box

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Were any diagnostic trouble codes (DTCs) stored?

YES
Refer to Verification
NO
Refer to Checking the door locking function