Checking the wiring and switches

Check the signal cable for the lock position sensor between the central electronic module connector terminal #C3 and lock unit connector terminal #5. Check for an open-circuit.

NOTE:

Diagnostic trouble code (DTC) REM-6A0C or REM-6A0E may also be stored if this fault occurs. Click the VCT2000 symbol to read diagnostic trouble codes (DTCs).

Other information:

To access and replace the lock module, see Driver's door module / passenger door module (DDM/PDM), replacing
For information on the central electronic module connectors, see Central electronic module (CEM), replacing
To connect the breakout box, see Connecting the breakout box
For further information about signals and other values:
- -2004: Signal specification
- 2005-: Signal specification
See Checking wiring and terminals. Intermittent faults .

Fig 1: Breakout Box

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Were any diagnostic trouble codes (DTCs) stored?

YES
OKAY: Troubleshooting has been completed.
NO
Refer to Checking the door locking function