Checking the cable

Check the cable between central electronic module connector terminal #20A and the ignition switch connector terminal #50. Check for an open-circuit according to Open-circuit, intermittent faults . Check for a short-circuit to ground according to Short-circuit to ground, intermittent faults .

Other information 

• The voltage must be the same as battery voltage if the key is in position III
• To access or replace the central electronic module (CEM) connector, see Central electronic module (CEM), replacing
• To connect the breakout box, see Connecting the breakout box
• For further information about signals and other values:
  • -2004: Signal specification
  • 2005-: Signal specification

Fig 1: Breakout Box

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohm Meter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Central Electronic Module (CEM) Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.