Checking the component and wire

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.

  Check the wire between central electronic module (CEM) connector #20A and ignition lock connector #50 (#7) for an open circuit as described in Open-circuit, permanent faults , and for a short circuit to ground as described in Short-circuit to ground, permanent faults .

  Additional information: 

  • The voltage should be the same as the battery voltage if the key is in position III.
  • To access/replace the CEM connector, see Central electronic module (CEM), replacing
  • To connect the test box to the control unit, see Connecting the breakout box
  • For further information about signals and other values:
    • -2004: Signal specification
    • 2005-: Signal specification
  Fig 2: Breakout Box

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 3: Identifying Ohm Meter

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 4: Identifying Power Cable Terminals

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the voltage the same as the battery voltage? 

• YES 

  Refer to Verification 

• NO 

  Refer to Replacing the component