For cleaning/assembly and greasing the outer joint, see below
NOTE:
The joint can be cleaned when assembled and blown clean before greasing. See Lubricate the constant velocity joint thoroughly . For disassembly and inspection, see Mark the outer constant velocity joint outer ring, ball holder and inner ring , Remove the ball bearings , Remove the ball bearing holder and the inner ring from the shaft , Wash the constant velocity joint components thoroughly and Install the inner ring in the ball holder . For greasing, see Lubricate the constant velocity joint thoroughly . To install the boot and joint, see Replace the snap ring , Install the new boot/boots on the drive shaft , Apply grease in the boot and Vent the boot .