LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> S80 Base, 2.5 59, FWD >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Axle, Drive Shafts - Removal, Replacement And Installation >> Drive Shaft, CV Joint (Ambulance; 2003-2004) >> Boot, half shaft, replacing >> Brush the drive shaft thoroughly with soapy water

Brush the drive shaft thoroughly with soapy water

Fig 1: Pressing Out Vibration Damper From Drive Shaft
GLL109817Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the drive shaft on a support in a workshop press. Carefully press out the vibration damper from the drive shaft.

Clean the assembled constant velocity joint and blow clean. Grease the joint. See Lubricate the constant velocity joint thoroughly 

Install the boot on the shaft. Carry out operations Apply grease in the boot  and Vent the boot 

scientia non olet · About LEMON Manuals