LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> S80 Base, 2.5 59, FWD >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Axle, Drive Shafts - Removal, Replacement And Installation >> Center Differential (Ambulance; 2001-2002) >> Bearing viscous coupling, replacing >> Installation >> Installing the viscous coupling into the viscous coupling housing

Installing the viscous coupling into the viscous coupling housing

Fig 1: Identifying Viscous Coupling
GLL109836Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the viscous coupling as marked. See Removing the screw for holding the flange to the viscous coupling .

NOTE: Check that the loose washer is in place.
Fig 2: Identifying Counterhold With Adaptor Flange
GLL109870Courtesy of VOLVO CARS OF NORTH AMERICA.

Use a new screw  . Tighten to 50 Nm  . Use counterhold 9995759 with adapter 9995759 .

NOTE: After installing the viscous coupling housing, see Final drive, transferring components  .
scientia non olet · About LEMON Manuals