Checking the wiring and sensor

Check the wiring between brake pressure sensor 2:

for an open circuit as described in Open-circuit, permanent faults , a short circuit to ground as described in Short-circuit to ground, permanent faults , and a short circuit to voltage supply as described in Short-circuit to supply voltage. Permanent faults .

HINT: With the ignition on and the test box connected, check brake pressure sensor 2 by testing the sensor signal between

#26 and #41 on the test box. The voltage should be approximately 5 V.
#10 and #26 on the test box. The voltage should be between 0.25-4.75 V, depending on the brake pressure.

Do the necessary corrective action.

Additional information:

Fig 1: Identifying Pedal Position Sensor Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Is there a fault?