Checking the wiring and component
Check the wires between control unit #47 and the battery for an open circuit as described in Open-circuit, permanent faults , and for a short circuit to ground as described in Short-circuit to ground, permanent faults .
Check to see if fuse 4 in the engine compartment relay/fuse box has blown. If the fuse has blown, check the wire between the fuse and control unit #47 for a short circuit to ground as described in Short-circuit to ground, permanent faults and replace the fuse.
Do the necessary corrective action.
Additional information:
- To connect the test box, see Connecting the ABS/DSTC breakout box .
Is there a fault?
- YES
Refer to Verification
- NO
Refer to Checking pump motor circuit