Checking the wires and components

Check the fuse 11D/4 is intact.

Check that the reversing lamp bulbs are intact.

Check the wires between fuse 11D/4 2 and relay 2/80 5 and relay 2/80 3 and left and right upper lamp body contact 3 for an open circuit as described in Open-circuit, permanent faults and short circuit to ground as described in Short-circuit to ground, permanent faults .

Check wire between left and right upper lamp body connector 1 and ground point for an open circuit as described in Open-circuit, permanent faults .

Do the necessary corrective action.

Additional information: 

• For information about signals and other values, see Signal specification and Signal specification
• To connect the test box, see Connecting the breakout box
• To access relay/fuse box in the boot, see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing .

Fig 1: Identifying Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Relays

Courtesy of VOLVO CARS OF NORTH AMERICA.