Checking the tilt sensor

Check the rear electronic module connector and the tilt sensor connector for defects and an open-circuit.

Check the ground connection between tilt sensor connector terminal #5 and ground terminal 31/72. Check the cable and connector in the cable harness between these two points. See Open-circuit, permanent faults and Open-circuit, intermittent faults .

Other information 

• For information about signals:
  • For MY -2003, see Signal specification
  • For MY 2004, see Signal specification
• To connect the breakout box, see Connecting the breakout box .

Fig 1: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Was a fault detected? 

• YES 

  Refer to Verifying sensors 

• NO 

  Refer to Replacing sensors