Expose the engine cable harness
WARNING: This page is about a different variant/trim than selected.
Disconnect all connectors and clamps from engine.
NOTE:
Note all the cable harness mountings positions.
- Thermostat
- Generator (GEN)
- Air conditioning (A/C) if installed
- Ground terminal
- Oil pressure switch
- Oil level sensor
- Starter motor (all)
- Knock sensor (KS)
- Ground terminal
- Ground terminal
- Throttle housing switch
- Idle air trim
- Flywheel sensor
- Injectors
- Camshaft position (CMP) sensor
- Back-up (reversing) lamp switch
- Mass air flow (MAF) sensor
- Vehicle speed sensor (VSS)
- Heated oxygen sensor (HO2S) (automatics x 2)
- PTC element