Install the engine cooling fan (FC): Notes

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Upper Charge Air Pipe, Fresh Air Intake, Upper Fan Shroud, Pressure Pipe And EVAP Canister Shut-Off Valve

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove shroud ( 9995474 ) from radiator.

Lift out the engine cooling fan (FC) with the cover. Connect the connector, clamp the wiring.

Install the upper charge air pipe, between charge air cooler and turbocharger (TC).

Install the fresh air intake.

Install the upper fan shroud. Tighten the fan shroud to the radiator (ensure that the clip is in place.

Connect the pressure pipe (to the turbo instruments).

USA: Connect the vacuum hoses to the EGR-regulator.

Install the EVAP canister shut-off valve in the bracket and connect the canister vacuum hose.

Install:

Fig 2: Identifying Air Duct, Fan Shroud Relays And Idle Air Trim

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

Fig 3: Identifying Cable To PTC-Element And Heated Oxygen Sensor (HO2S)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Car with manual transmission:

back-up (reversing) light switch cable
the gear selector cables rubber mounting.
gear selector cables to their mounting on the transmission.
NOTE: Color marking mounting/cable.

Cars with automatic transmission:

Connect connector to the transmission.

Install gear selector cable (as marked earlier)

Install two transmission oil cooler hoses and negative lead to the transmission.