Install fuel rail

Fig 1: Identifying Fuel Rail Protective Cover

Courtesy of VOLVO CARS OF NORTH AMERICA.

Grease O-rings for injectors.

Tighten fuel rail.

Remove holder 9995533 .

Install: 

Fig 2: Identifying Upper Radiator Hose, Expansion Tank, Auxiliaries Belt And Power Steering Pump Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

• the protective cover over the fuel rail
• fuel line clip (upper/lower)
• auxiliaries belt
• expansion tank with radiator pipes
• upper and lower oil cooling hoses

Install: 

Fig 3: Identifying Starter Motor Bracket, Cold Air Hose, Radiator Hoses And Fresh Air Intake Hose

Courtesy of VOLVO CARS OF NORTH AMERICA.

• starter motor bracket and its splash guard
• cold air hose
• radiator hoses to the cowl panel
• fresh air intake hose to the turbocharger (TC)

Install: 

Fig 4: Identifying Idle Air Trim With Lower Charge Air Pipe, Lower Radiator Hose, Starter Motor Protective Cover And Battery Negative Lead

Courtesy of VOLVO CARS OF NORTH AMERICA.

• negative lead to the engine, and install the clamp on the frame member
• lower radiator hose
• clutch slave cylinder to the gearbox
  NOTE: (Take care that the piston does not slide out)
• slave cylinder snap ring
• the rubber air filter mountings and tighten bracket.
• idle air trim, connect connector