Turbocharger, exhaust manifold/gasket, replacement.: Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
For tightening torques, see Tightening torque
.
NOTE:
To ensure that there is no exhaust leakage, see Flanged joint, assembling
.
Fig 1: Identifying Charge Pressure (Red-Marked), Relief Valve (White-Marked) And Pressure Box (Yellow-Marked)
- new studs (if any are missing) are tightened with 20 Nm .
- the turbo unit.
- hoses acc. to marking.
- the exhaust manifold's both upper nuts, and tighten slightly.
Raise the car.
Install:
- the exhaust manifold's lower nuts.
Tighten with 25 Nm .