Remove components

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Underhood View

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION: Remove the ignition key from the ignition switch before beginning work.

NOTE: The crankshaft or camshaft must not be rotated under any circumstances other than those listed below. Failure to follow these instructions may cause damage to the valves.

Remove:

the upper timing belt cover.
the servo reservoir and the expansion tank.
Lift up and place on top of the engine.

NOTE: Take care not to spill servo oil from the bleed hole in the cap. Place paper wipe around the reservoir and then cover with a plastic bag as protection. Spilled servo oil is highly inflammable.
the auxiliaries belt.
the front camshaft belt cover.