Install the flame trap

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Flame Trap Hoses And Intake Manifold Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

Connect the two flame trap hoses to the cylinder block connecting sleeves.

Install a new hose clamp for the upper hose. Tighten the lower clamp.

Install and tighten the screws to 20 Nm .

Install the intake manifold bracket loosely with the lower screw.

Install the intake manifold:

Install the intake manifold according to procedure Intake manifold/gasket, replacing .